XP Deus Control unit Tether
SKU:
$10.00
$7.00 - $10.00
per item
Have you ever had your control unit pop off that slick mounting shoe system unexpectedly? Mr. Ralph Magee did, and so he asked if I could design and 3d print up a tether to assure the control unit does not get lost. Since Ralph and I first discussed this issue, I have heard of two others actually losing their control units.
This tether ring simply slides over the XP Deus control unit and is held snugly in place with a Teflon thumb screw. The other end of the coiled tether attaches to the shaft with the included Velcro strap.
After choosing one of the 17 available colors you want, you can add personalized text to the tether by clicking yes to that option.
When you check out, enter the text you want in the "Note to Seller" section of the order form.
This tether ring simply slides over the XP Deus control unit and is held snugly in place with a Teflon thumb screw. The other end of the coiled tether attaches to the shaft with the included Velcro strap.
After choosing one of the 17 available colors you want, you can add personalized text to the tether by clicking yes to that option.
When you check out, enter the text you want in the "Note to Seller" section of the order form.
The design has been enhanced since the pictures above were taken. It now incorporates two nylon screws that line up with the two counter-bored holes on back of the Deus' Control unit. The screws effectivly become pins locked into the holes. I will get new pictures up as time allows.
Installation instructions showing the new design are below.
Installation instructions showing the new design are below.